Eliminate hard water spots on your car, boat, plane or windows with GWS ZeroSpot. Simply wash, rinse and walk away for a spotless gleaming shine. Perfect for car detailing and for your home. The portable system is capable of producing hundreds of gallons* of de-ionized water.
*results may vary depending on actual water quality
|Max. Pressure||125 psi /8.6 bar (based on filter housing rating)|
|Recommended Pressure||45 psi / 3 bar|
|Max. Flowrate||2.5 GPM / 9.5 LPM|
|Recommended Flowrate||1 GPM / 4.5 LPM|
|Temperature||5°C - 40°C / 40°F - 104°F|
|Inlet Water Connection||3/4″ BSPT/NH|
|Garden Hose Connection||3/4″ BSPT/NH|
The ZeroSpot should be installed before the pressure washer or pressure pump. Please ensure to purge hose connections installed after the ZeroSpot and run water through the unit before drawing with a pressure washer. As the max draw/flow rate of consumer-grade pressure washers may vary, please first check to ensure the pressure washer specifications are compatible with the ZeroSpot, which has maximum flow rate of 9.5LPM (2.5GPM). If used with pressure washer that has a higher draw/flow rate than the ZeroSpot, or with a pressure washer that requires the use of a holding tank, then it is recommended for the user to fill a clean auxiliary holding tank that is dedicated for deionized water and not connect the pressure washer directly to the ZeroSpot. If used incorrectly or with an incompatible pressure washer (in terms of flow rate), there is a risk of cavitation which may/will cause damage to the ZeroSpot.
The exhausted media is categorized as non-hazardous commercial waste and is landfill safe. Please also consult with your local waste collection service for the relevant disposal policy.
|Treatment Capacity Table – Recommended rinse parameters (45 psi / 4.5 LPM)|
|Feed Water TDS (ppm)||Treated water (L)||Treated water (gal)||# of rinses @ 3 minutes of spray||# of rinses @ 5 minutes of spray|
Using ZeroSpot with extremely hard water will cause the system to become exhausted at a faster rate.
If the system is not being used, store the system indoors. For storage, avoid exposure to direct sunlight and protect from the elements. Avoid freezing to prevent damaging the system.
If the system is not being used for more than 3 weeks, relieve hose pressure, open the housings using supplied wrench, remove cartridges and empty water from housings. Place cartridges in a location that will not create water damage, i.e., a sink or drain. Allow cartridges to drain completely before returning them to the housings.
The resin cartridges have a shelf life of more than two years. After two years, the resin’s capacity will gradually start to decline at a rate of approximately 3-5% per year.